Carrier reefer · Yuma, AZ · 2026-11
Call (520) 257-2283Request reefer service["carrier reefer upper belt broke off","belt slipped half off"]
When a Carrier reefer upper belt breaks or slips off, the most common culprit is a worn or seized tensioner pulley. Over time, the internal bearings inside the tensioner wear down, causing the pulley to misalign or lock up completely. This sudden friction or misalignment rapidly shreds or throws the drive belt off its tracks. Other common causes include a seized alternator or compressor clutch, improper belt tension during previous maintenance, or heavy debris caught in the pulley grooves. If your reefer belt has thrown or snapped, start with a visual check with the unit turned off. Look closely at the tensioner pulley to see if it sits at an angle or shows sign of metal shavings and metal-on-metal wear. Check if driven pulleys turn smoothly by hand or if one is completely locked up. Never run the reefer unit with a misaligned or missing drive belt, as loss of cooling will quickly risk your perishable cargo. Replacing just the belt without replacing a bad tensioner pulley will usually cause the new belt to snap almost immediately, so both parts should be replaced together by a technician.
Driver reported the upper belt on a Carrier reefer unit broke off and slipped. Dispatch advised that a failed tensioner pulley is typically the root cause when reefer belts snap.
unknown
Real calls handled by MTS dispatch. Names, phone numbers and prices are removed.
Real calls handled by MTS dispatch. Names, phone numbers and prices are removed.
When a reefer unit display shows rapid temperature fluctuations—jumping from 33 down to 26 and up to 46 degrees within seconds while the set point remains steady—the issue is almost always electrical or sensor-related rather than a mechanical cooling failure.…
When a reefer unit displays a check evaporator airflow alarm and shuts down after running for five to seven minutes, the micro-controller is protecting the unit from freezing or overheating due to restricted air circulation across the evaporator coil. The mos…
When a Thermo King reefer unit fails to turn on or start, a dead or weak battery is one of the most common causes, especially if the unit previously gave low voltage warnings. Start by checking the battery connections to ensure the cables are clean, tight, an…
When a Carrier reefer unit repeatedly throws or rips its main compressor belt, the issue usually stems from misaligned pulleys, a failing belt tensioner, worn compressor clutch bearings, or an overloaded compressor. A weak tensioner allows the belt to flap un…