Topeka, KS · 2026-11
Call (316) 710-8655Request reefer service["reefer won't start","clicks when starting","new battery installed"]
When a reefer unit only clicks after installing a brand new battery, the issue is typically electrical or starter-related rather than a dead battery itself. The most common culprit is a bad ground connection or loose or corroded battery terminals installed during the battery swap. A poor connection allows enough current to trigger the starter solenoid—causing that clicking sound—but fails to pass the heavy amperage required to turn the starter motor over. Other likely causes include a failed starter motor, a faulty starter solenoid, or a blown main fuse or relay in the reefer control box.
Before calling for roadside service, safely check the battery cable connections. Make sure the positive and negative terminals are completely clean, tight, and free of corrosion. Trace the main ground wire to the unit frame to ensure it is securely bolted to clean, bare metal. Next, check the reefer control panel display for active fault codes and inspect all main inline fuses or circuit breakers. If all connections are clean and tight, the battery shows full voltage, and the starter still only clicks, a mobile technician will need to perform a voltage drop test, check starter draw, and inspect the control board circuits.
Reefer unit clicks when trying to start after a battery replacement; cause not confirmed on the call
unknown
Real calls handled by MTS dispatch. Names, phone numbers and prices are removed.
Real calls handled by MTS dispatch. Names, phone numbers and prices are removed.
When a Thermo King reefer trips code 619 alongside a low battery voltage code, it indicates the control unit is detecting insufficient operating voltage or a failure in the ECU main relay circuit. Even with a brand-new battery installed, electrical issues els…
When a reefer unit displays a check evaporator airflow alarm and shuts down after running for five to seven minutes, the micro-controller is protecting the unit from freezing or overheating due to restricted air circulation across the evaporator coil. The mos…
When a Thermo King reefer unit fails to turn on or start, a dead or weak battery is one of the most common causes, especially if the unit previously gave low voltage warnings. Start by checking the battery connections to ensure the cables are clean, tight, an…
When a Carrier reefer unit repeatedly throws or rips its main compressor belt, the issue usually stems from misaligned pulleys, a failing belt tensioner, worn compressor clutch bearings, or an overloaded compressor. A weak tensioner allows the belt to flap un…