Carrier reefer unit · 2026-11
Call (855) 450-1212Request reefer service["reefer temperature reading jumping periodically","reefer temperature out of range"]
When a Carrier reefer unit displays rapidly jumping temperatures or out-of-range readings, the issue is almost always a failing return air sensor, supply air sensor, or damaged sensor wiring. Moisture ingress, wire corrosion, or internal thermistor breakdown inside the probe will cause erratic resistance signals sent to the micro-processor. A driver can check the display panel for active alarm codes, verify external wiring harnesses near the bulkhead for visible damage, and cross-check the box temperature using an independent pulp thermometer. However, if the fluctuating sensor is located inside the evaporator assembly behind the bulkhead, the trailer cargo must be unloaded before a mechanic can access and replace the component. A mobile reefer technician can pin out the sensor harness at the control module using a digital multimeter to measure resistance and confirm a failed sensor versus a main control board fault.
Technician diagnosed an internal temperature sensor failure inside the Carrier reefer unit causing wild temperature fluctuations; replacement requires unloading the trailer cargo first
parts needed
Real calls handled by MTS dispatch. Names, phone numbers and prices are removed.
Real calls handled by MTS dispatch. Names, phone numbers and prices are removed.
When a reefer unit displays a check evaporator airflow alarm and shuts down after running for five to seven minutes, the micro-controller is protecting the unit from freezing or overheating due to restricted air circulation across the evaporator coil. The mos…
When a Carrier reefer unit repeatedly throws or rips its main compressor belt, the issue usually stems from misaligned pulleys, a failing belt tensioner, worn compressor clutch bearings, or an overloaded compressor. A weak tensioner allows the belt to flap un…
When a reefer unit display screen is completely blank and the unit fails to respond or turn on, the issue is almost always related to primary electrical power feed to the reefer microprocessor or control panel. The first thing a driver should check is the mai…
When a Carrier reefer unit starts up and immediately shuts down with a system problem warning, it typically points to a protective shutdown triggered by the unit controller. The most common causes include air in the fuel lines, low fuel pressure, low engine o…
When a reefer unit set to 33 degrees fluctuates wildly between 28 and 46 degrees before triggering a high-temp alarm and reaching 50 degrees, several refrigeration components could be at fault. A common cause is an evaporator coil icing over due to a failing …