Freightliner straight truck with Carrier reefer · Smithville, ON · 2026-11
Call (855) 450-1212Request reefer service["reefer shutting down","reefer temperature reading 8 degrees"]
When a Carrier reefer unit on a straight truck repeatedly shuts down during pre-cooling, the unit's controller is likely triggering a safety shutdown. Common causes include clogged fuel filters causing fuel starvation, low engine oil pressure, low engine coolant levels, or a faulty temperature sensor providing incorrect readings to the module. Refrigeration side issues, such as high discharge pressure or low refrigerant charge, will also prompt an automatic shutdown to protect the compressor.
Before calling for service, check the display panel for active alarm codes. Note any fault numbers shown on the controller screen, as these pinpoint whether the failure is engine-related or refrigeration-related. Inspect the reefer engine compartment to verify oil and coolant levels are adequate, and check the fuel filter for water or air in the lines.
If basic fluid checks pass and the unit continues to stall, a qualified technician needs to test the sensors, fuel system, and electrical controls. Keep in mind that while sensors, filters, starter components, and electrical issues can usually be fixed on-site by a mobile mechanic, major refrigerant leaks or Freon recharges require containment equipment best handled inside a dedicated repair facility.
Cause not confirmed on the call
unknown
Real calls handled by MTS dispatch. Names, phone numbers and prices are removed.
Real calls handled by MTS dispatch. Names, phone numbers and prices are removed.
Thermo King alarm codes 86 and 87 typically point to issues within the discharge and suction pressure sensor circuits or extreme pressure readings. Code 86 indicates a discharge pressure sensor check or high discharge pressure alarm, while code 87 relates to …
When a reefer unit displays a check evaporator airflow alarm and shuts down after running for five to seven minutes, the micro-controller is protecting the unit from freezing or overheating due to restricted air circulation across the evaporator coil. The mos…
When a Thermo King reefer unit fails to turn on or start, a dead or weak battery is one of the most common causes, especially if the unit previously gave low voltage warnings. Start by checking the battery connections to ensure the cables are clean, tight, an…
When a Carrier reefer unit repeatedly throws or rips its main compressor belt, the issue usually stems from misaligned pulleys, a failing belt tensioner, worn compressor clutch bearings, or an overloaded compressor. A weak tensioner allows the belt to flap un…